Pololu Wixel Manuel d'utilisateur télécharger pdf (Page 26)

• You loaded a program which uses a different type of USB interface or no USB interface. In this case, check

the documentation of the app to see if there is a convenient way for getting the Wixel into bootloader mode.

No matter what state the Wixel is in, you can manually get it into bootloader mode by connecting USB, setting P2_2

high, and resetting the Wixel.

There are two main ways to accomplish this.

One way is to disconnect the Wixel from any possible power sources, connect P2_2 to 3V3 using a wire, and then

plug it into USB.

Using a wire to put the Wixel into bootloader mode.

Another way to is to wire a bootloader button and a reset button to the Wixel and follow the procedure shown in the

picture below:

Using pushbuttons to put the Wixel into bootloader mode.

5. Connecting Your Wixels Page 26 of 64

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 63 64

Pas de commentaire

Pololu Wixel Manuel d'utilisateur Page 26